Graduation card number 1

...made for the same person as yesterday's 21st birthday card.  Again the brief was 'girly'.

I used a scalloped edge 8" base card and the backing paper is cut from a 12" DCWV sheet. I ran it through the printer to add the sentiment then went over the lettering with Diamond Stickles to bling it up a bit...


The mortar board was cut using the craft robo (have had a lot of use out of it lately, lol!) and layered with 3d foam pads.  Don't you just love the tassel (which cost more than the rest of the card put together!)


And yes you've guessed it, there's a box too, although this 1 is a bit plainer than usual.  The tag was designed in Word after I'd used Photoshop Elements to recolour the ribbon on the clipart scroll.

Check back tomorrow for another graduation card...